RUSH MODEL NO 250A Manual 3/32″-2″ DRILL & TOOL GRINDER W/ 6 JAW CHUCK

RUSH MODEL NO 250A 3/32″-2″ DRILL & TOOL GRINDER W/ 6 JAW CHUCK

Model 250 have a capacity of 3/32″ to 2″ diameter. Model 250A has a 2:1 ratio only. Model 250A uses hardened cams, and the cam change takes only 5 seconds. When no cam is in place the workhead can be used to spin grind or index grind (12 positions). Model 250A incorporates a wide capacity and versatility in an affordable package. The innovative design of the 250A allows for grinding of almost any drill geometry, and most are completed in a single chucking. The versatility also extends to taps, reamers, countersinks, and end mills. Many of these tools can be ground with very little setup

EQUIPPED WITH:

Manual Feed

6 JAW CHUCK

LOC 4E